how to attach deer antlers to wood

Best answer


To attach your antlers to this wooden base,drill a couple holes through the skull cap, about 1.5鈥?apart. Then with slightly larger screws, fasten it down to the wood. If the screws are slightly long and protrude through the other side, I grind them flush with a bench grinder.

People also ask


  • How do you Mount Deer antlers on a wall?

  • Use the thickest part of the skull plate, as that will be the sturdiest part to hold the mount in place. These will need to match the size and position of the holes on the plaque. Secure the antlers to the plaque. Insert drywall screws into the holes you just made, and into the holes you’ve drilled in the plaque.

  • How to cut deer antlers off?

  • Cut the antlers out of the skull. Cut through the skull at the base of the antlers, making sure to keep part of the skull plate as you go around it. You should not take only the antlers. A small oval around the base will help everything hold together. A handsaw or hacksaw should be enough to cut through the bone.

  • How do you Mount antlers on a skull plate?

  • Mounting the Antlers Drill holes into wood plaque. This will either be two or three holes depending on the size of your skull plate. Drill holes in the skull plate. Use the thickest part of the skull plate, as that will be the sturdiest part to hold the mount in place. Secure the antlers to the plaque.

  • What is the best wood to mount a deer antler?

  • Pine, oak, walnut, and cherry all are fine examples of mounting woods. Choose wood with appealing grains. Purchase a plank with a thickness between 1 inch by 6 inches (2.54 cm by 15.24 cm) and 1 inch by 20 inches (2.54 cm by 50.8 cm). It is not advised to mount antlers on wood planks thinner than 1 inch by 6 inches.

    Leave a Reply

    Your email address will not be published.